+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: a nuther magnetic bace (/thread-618.html)
Pages:
1
2
a nuther magnetic bace - krv3000 - 07-14-2012
hi all went to see john to day nice chap i got off him a magnetic base a dti stand to be precise so when i got home this was the job for today furs of all i removed the rod then the magnet i had to use sum heat to remove sum sort of filler then cleaned it all up in the 4 jaw chuck put the magnet back in with sum grease all ready for panting right piks thanks john
RE: a nuther magnetic bace - doubleboost - 07-14-2012
Hi
Bob
Next time you come up you can take my other mag bases away with you and referbish them
Nice to see it being put to use
Thanks for the floor mat
John
RE: a nuther magnetic bace - krv3000 - 07-14-2012
no problem john i forgot to fetch up strip lights they take 3ft tubes i got two for you
RE: a nuther magnetic bace - DaveH - 07-14-2012
Bob,
Now it is all nice and refurbished John will be wanting it back
DaveH
RE: a nuther magnetic bace - krv3000 - 07-14-2012
ok he can have it back if he swops it for his mill
RE: a nuther magnetic bace - sasquatch - 07-14-2012
Nice job Bob, thanks for posting the neat pics!!
RE: a nuther magnetic bace - dallen - 07-14-2012
(07-14-2012, 03:58 PM)krv3000 Wrote: hi all went to see john to day nice chap i got off him a magnetic base a dti stand to be precise so when i got home this was the job for today furs of all i removed the rod then the magnet i had to use sum heat to remove sum sort of filler then cleaned it all up in the 4 jaw chuck put the magnet back in with sum grease all ready for panting right piks thanks john
I have a couple of this type base that came out of China and they don't hold so good. I read a blog over on Alloy Avenue where one of the guys made his base from scratch, I would like to change the magnets in mine to some that will hold but haven't been able to find magnets the right shape.
Anyone know of a source, I can get ones that are magnetize the right direction but none that are the oblong shape, and I don't really want to have to make a carrier to hold a cylinder.
DA
RE: a nuther magnetic bace - Mayhem - 07-14-2012
Have a look on eBay, there are tons in different shapes and sizes.
RE: a nuther magnetic bace - krv3000 - 07-16-2012
hi all well the last bit well no one spotted the problem that it had panted it red re labeled the on and off points right pics the problem was their was two balls missing out of the fine ajusment post
RE: a nuther magnetic bace - doubleboost - 07-17-2012
Nicely done Bob
I am pleased it went to a good home