+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Milling Machines (http://www.metalworkingfun.com/forum-12.html)
+--- Thread: Making Swarf (/thread-4455.html)
Making Swarf - rleete - 10-02-2022
Decided it was time to get back to machining something. This is cast aluminum (scrap from work), and I must say it is not as nice to machine as 6061.
Ed must be appalled at the state of my little mill!
[attachment=18006]
More pics to come as this project takes shape.
RE: Making Swarf - EdK - 10-02-2022
Shop vac to the rescue!Ed
RE: Making Swarf - Vinny - 10-03-2022
I keep a shop vac plugged in and sitting right next to the mill. The lathe? Not so much..
RE: Making Swarf - rleete - 10-03-2022
I managed to snap off a 1/2" carbide end mill last night. Started to chatter, and as I backed off, it let go. General consensus of the toolroom guys is that it was probably cracked from looking at the broken end. I dropped it the day before, so that may have been what caused that. I knew I was pushing it (DoC too large), but I was in a hurry to finish. I should know better.
Put a small gouge in the part, so I'll have to figure out a way to hide that.
Either way, that put an end to machining for the night.
RE: Making Swarf - EdK - 10-03-2022
That sucks. Not a pleasant way to end the evening.
Ed