+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: 3D Printing (http://www.metalworkingfun.com/forum-46.html)
+--- Thread: Share your prints (/thread-4303.html)
RE: Share your prints - EdK - 07-07-2021
Not much but I added a chuck key holder for the 4-jaw chuck. It's been so dead around here I thought I'd go ahead and post it.
Ed
[attachment=17180]
RE: Share your prints - EdK - 07-10-2021
Again, nothing fancy. Just a holder for the lathe dogs. I forgot to add spots to accommodate the drive pins so I had to make it separate.
Ed
[attachment=17193]
RE: Share your prints - EdK - 07-17-2021
Made a carriage stop for the mini lathe.
Ed
[attachment=17226] [attachment=17227]
[attachment=17228] [attachment=17229]
[attachment=17230]
RE: Share your prints - EdK - 08-20-2021
Nothing new, just another collet holder since I bought three more collets. The 4th one is on back order.
Since it's dead around here I thought I'd post it anyway.
Ed
[attachment=17284]
RE: Share your prints - EdK - 08-24-2021
Tool holder for my drill press. The two chuck keys are a bit too close together but they work. I'll add 1/8" to the distance between them to the drawing just in case I reprint this at a later date. The two open spots are for two more strap clamps.
Ed
[attachment=17300] [attachment=17301]
[attachment=17302]
RE: Share your prints - EdK - 08-26-2021
Printed this hygrometer holder that snaps into the center of the filament spool. I can monitor the humidity while in the bag.
Got the STL file off of Thingaverse.
Ed
[attachment=17304] [attachment=17305]
RE: Share your prints - EdK - 08-26-2021
Printed up some blocks for hanging my QCTP tool holders. I've got 11 holders, 5 unused. I can add two more blocks to the wall, I just need to print them.
Ed
[attachment=17306] [attachment=17307]
RE: Share your prints - EdK - 12-25-2021
Made a box for my thread gauges. I stored them for many years in the plastic pouches they came in but they don't stack very well so I printed up a box with a sliding lid to hold them.
Ed
[attachment=17401] [attachment=17402]
[attachment=17403]
RE: Share your prints - EdK - 12-31-2021
Another box, this time for the bench block.
Ed
[attachment=17472] [attachment=17473]
RE: Share your prints - arvidj - 12-31-2021
I see that you are using different colors for your containers. I am assuming that is so you know what is inside without having to open them. I know I'd lose track of what I had stored in them about 10 minutes after I put the container in the drawer.