Tapping titanium......HELP! - Printable Version +- MetalworkingFun Forum (http://www.metalworkingfun.com) +-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html) +--- Forum: Lathes (http://www.metalworkingfun.com/forum-11.html) +---- Forum: Lathe Tooling (http://www.metalworkingfun.com/forum-19.html) +---- Thread: Tapping titanium......HELP! (/thread-4233.html) |
Tapping titanium......HELP! - Swarf_Newbie - 09-10-2020 Don't know if this is the right place for this but, I'm trying to tap m8x1 in a piece of GR5 titanium, do I need special taps, 'cos my normal tap wont even try! pulling my hair out here!😒 Cheers. Roy. RE: Tapping titanium......HELP! - Dr Stan - 09-11-2020 Sounds like a good time to call your tooling rep. They will have a direct line to the tap manufacturing engineers who can advise him and then you on what to get and what sort of cutting/tapping lube to use. RE: Tapping titanium......HELP! - Dr Stan - 09-12-2020 Take a look at this: https://www.youtube.com/watch?v=ASd1VysHX64 There are several other YouTube vids on working with titanium. RE: Tapping titanium......HELP! - Swarf_Newbie - 09-13-2020 Thanks Dr Stan, so that looks like a yes then to the special tools! 😎 Cheers. Roy. |