+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Project Ideas (/thread-4189.html)
Project Ideas - TomG - 05-31-2020
I came across this channel on YouTube that is a good source of information on the design of various machining fixtures and accessories. It's all in Russian, but a picture is worth a thousand words (and a video is even better). One that caught my eye was a radius attachment for a small lathe. There was nothing radically different about it, but it was very well designed.
Tom
KULEBYAKIN
RE: Project Ideas - Clifford B. - 06-03-2020
Some cool stuff there thanks fer the link, got it book marked fer future inspiration.............
RE: Project Ideas - weldergirl88 - 11-09-2021
(05-31-2020, 09:08 AM)TomG Wrote: I came across this channel on YouTube that is a good source of information on the design of various machining fixtures and accessories. It's all in Russian, but a picture is worth a thousand words (and a video is even better). One that caught my eye was a radius attachment for a small lathe. There was nothing radically different about it, but it was very well designed.
Tom
KULEBYAKIN
Just tried to pull it up. Says it has been pulled down to 3 party problems
RE: Project Ideas - TomG - 11-09-2021
Copyright infringement never pays off.
Tom
RE: Project Ideas - bl00 - 12-05-2021
Is this the same person?
Кулебякин Джо (Kulebyakin Joe)
https://www.youtube.com/channel/UC8KKP5xk6kZp8oYdsE27E1Q/videos