+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: CNC (http://www.metalworkingfun.com/forum-28.html)
+--- Thread: CNC Control Board (/thread-3891.html)
CNC Control Board - Nikon1975 - 05-09-2018
Dear All,
I am trying to study the mechanic, electronic and software associated to the CNC. I have quite a clear idea about the motors and the drivers. Where it get messy is on the control board or breakout boards. I do not have a parallel port, so I have to go either with USB or Ethernet.
I see boards from 20$ to 2000$ that on paper seems to have similar performances and most probably they are quite different.
How to select one ? I am oriented to something Mach3 compatible, as it looks like this software set a kind of standard.
On the other side there is the Arduino route. I am presently using the Arduino to use the motors as power feed, just to get familiar with the matter.
Thanks,
D.
RE: CNC Control Board - Hawkeye - 05-09-2018
I use Mach3 and I find it quite easy to use, once it is properly set up. As I recall, it only works with a parallel port. Mach4, on the other hand, works with USB and possibly Ethernet.
I've been using a common off-shore 4-axis board that seems quite workable. It is, of course, parallel-port driven, so it wouldn't work for you. I think you'd be doing okay to try one of the cheaper USB boards available on eBay.
RE: CNC Control Board - f350ca - 05-10-2018
Can't help much. I use Mach 3, easy to use on my plasma table. As Mike said think it only works with parallel and serial interface. Being electronically challenged I bought a package with the electronics already assembled and motors matched and tested.