+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: The Inimitable Harold Hall (/thread-3800.html)
The Inimitable Harold Hall - randyc - 01-01-2018
Many may recall a post by Mister Harold Hall a few months ago announcing his full retirement. For some years he has been an articulate and prolific source of tradecraft advice as well as a creative, innovative designer ! I found yet another of his fascinating tools today, a very useful one.
Note that there is a link to his web site that describes this tool in substantial detail. Thanks yet again Mister Hall.
http://www.homemadetools.net/forum/endmill-sharpening-device-end-cutting-edges-only-51508?homelistings#post74549
(Oh yes, in the retirement post, I recall Dr Stan referring to Hall as "Master Hall" which seems very appropriate.)
RE: The Inimitable Harold Hall - f350ca - 01-01-2018
Damm you Randy, now I have another project for the list.
Thanks just the same.
RE: The Inimitable Harold Hall - randyc - 01-01-2018
(01-01-2018, 08:58 PM)f350ca Wrote: Damm you Randy, now I have another project for the list.
Thanks just the same.
I agree, who needs another project, ha-ha-ha ? .... and just when I thought I could complete my little diamond grinder within the next few years.