+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: OOPS! (/thread-3335.html)
Pages:
1
2
OOPS! - Vinny - 09-30-2016
Saw this on Machinist Talk on FB. Hope everyone can see it 'cuze it's a link back to FB. I'm thinking someone just might be in trouble!
![[Image: 14441081_1061906063930504_31703983449418...e=585F8F15]](https://scontent-ort2-1.xx.fbcdn.net/v/t1.0-9/14441081_1061906063930504_31703983449418751_n.jpg?oh=41717c829741dd464adad6a6a1e269d9&oe=585F8F15)
RE: OOPS! - dallen - 09-30-2016
naw he'll be ok he's got that look about him that say's he has the knack of getting out of corners like the one shown.
RE: OOPS! - the penguin - 09-30-2016
that will buff right out..............................................................
RE: OOPS! - dallen - 09-30-2016
the dude in the back ground will probably be fired for making rude comments about his coworker
RE: OOPS! - Dr Stan - 09-30-2016
Better be careful if you're in the market for a used CNN mill.
RE: OOPS! - Highpower - 10-01-2016
Chum-Lee has a brother?
On the bright side, it could have been worse.
![[Image: 19806d1245195566-bad-day-forklift-bomb.jpg]](http://www.contractortalk.com/attachments/f11/19806d1245195566-bad-day-forklift-bomb.jpg)
RE: OOPS! - Dr Stan - 10-01-2016
OMG
RE: OOPS! - krv3000 - 10-01-2016
brill
RE: OOPS! - Mayhem - 10-01-2016
The forklift one looks staged to me. Would expect to the load to have been centred on the forks and to have actually moved away from the forklift as it started to tip.
RE: OOPS! - wawoodman - 10-01-2016
Somebody gots a lotta 'splainin' to do...