+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: Sector Arms for my dividing head (/thread-263.html)
Sector Arms for my dividing head - aametalmaster - 04-10-2012
I am building a dividing head from a new 40:1 gearbox and i needed some fancy sector arms made. So i made this simple fixture to make a nice round end. I cut the flats on my shaper ( i have a vid someplace) and then rounded the ends with my sander. I just sanded flush to the bushing that was cut the right size with a bolt holding everything together. I will post some pics of the DH build...Bob
RE: Sector Arms for my dividing head - DaveH - 04-10-2012
Bob,
They came out very nice
DaveH
RE: Sector Arms for my dividing head - aametalmaster - 04-11-2012
Here is a little vid of my SBL shaper cutting the arms. That thing runs like a swiss watch...Bob
http://s110.photobucket.com/albums/n86/aametalmaster/?action=view¤t=shaper004.mp4
RE: Sector Arms for my dividing head - EdK - 04-11-2012
(04-11-2012, 05:31 PM)aametalmaster Wrote: Here is a little vid of my SBL shaper cutting the arms. That thing runs like a swiss watch...Bob
http://s110.photobucket.com/albums/n86/aametalmaster/?action=view¤t=shaper004.mp4
Shapers are so mesmerizing to watch.
Ed
RE: Sector Arms for my dividing head - krv3000 - 04-12-2012
HI a job well dun
