+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: My new vice stop (/thread-2582.html)
My new vice stop - mike-sid - 03-15-2015
Here are some more pictures. Some guys spotted it on my DRO install thread. The only thing I did was make some bushings for the mounting screws. The supplied screws and holes were larger than My vice used. My mounting screws are 8mm. Some left over bushing is on the vice in one picture. It is real good quality, and very fair priced at $50. My vice is a 4" so I ordered the smaller stop.
![[Image: 20150315_182836_zpslfmiaily.jpg]](http://s204.photobucket.com/user/mike-sid/media/metalworking%20fun/20150315_182836_zpslfmiaily.jpg.html)
![[Image: 20150315_183050_zps0cbshqgh.jpg]](http://s204.photobucket.com/user/mike-sid/media/metalworking%20fun/20150315_183050_zps0cbshqgh.jpg.html)
![[Image: 20150315_183130_zpsaok8tfrd.jpg]](http://s204.photobucket.com/user/mike-sid/media/metalworking%20fun/20150315_183130_zpsaok8tfrd.jpg.html)
RE: My new vice stop - EdK - 03-15-2015
That's a work of art Mike. Very nice.
Ed
RE: My new vice stop - DaveH - 03-15-2015
It is very nice
trouble is I would keep it in it's box and not use it 
DaveH