+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: a skeleton clock refit (/thread-2043.html)
a skeleton clock refit - krv3000 - 03-10-2014
hi all well this kept me biz at the week end its a skeleton clock one of them cheep and nasty ones it had stopped working as the movement got gummed up with old oil and nigaten not a strait forward job to dismantle as the movement is held on to the dile backing plat witch is plastic and the dile is plastic to after sum cerfull levering i manged to remove the dile to get at the two screws to get the movement out gave it all a good scrub up put it back together this time using double sided tape to hold the dile back in place hung it up on the workshop wall and its ruining nice right pics
RE: a skeleton clock refit - DaveH - 03-11-2014
Nice job Bob,
Those things can be a bit tricky.
DaveH
RE: a skeleton clock refit - Micktoon - 03-11-2014
Hi Bob
, I have just had a little chuckle at the photo where you have all the parts laid out on the bench if I was doing this project the next photo would be it all in the bin 
I never seem to have any luck with such delicate type things...............Another good job done Bob, you are the man for the tricky fixes
Cheers Mick.
RE: a skeleton clock refit - doubleboost - 03-12-2014
Must have missed this post
Very well done mate
A bit on the small size for me
John
RE: a skeleton clock refit - Rifleman01 - 03-13-2014
With no disrespect meant Sir, you may have obtained the same result by placing the assembled item in a small ultrasonic tank with a suitable oil solvent and run it for a few minutes. The only thing to watch out for the solvent dissolving any plastic parts. Such tanks can be purchased for £15 -30 U/K pounds or possibly less in the USA. They are generally sold for cleaning jewellery.
Harry
RE: a skeleton clock refit - Brian - 03-14-2014
Nice job , simple clocks like that run forever with a little care and attention
it will be a nice work shop companion,
brian.
RE: a skeleton clock refit - krv3000 - 03-14-2014
thanks all yep i have bin looking at them ultrasonic tanks they seem to be a hand thing to have