MetalworkingFun Forum
Starrett 103-C Adjustment - Printable Version

+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Metrology (http://www.metalworkingfun.com/forum-33.html)
+--- Thread: Starrett 103-C Adjustment (/thread-1566.html)

Pages: 1 2


RE: Starrett 103-C Adjustment - PixMan - 08-05-2013

Sorry Chuck, but I just completely forgot to check and I'll be leaving for the airport in a few minutes.

I have to be careful in looking to send you one because with all the older micrometers my dad had that aren't as easy to read as my newer ones, I'm going to need a wrench for almost every one of them I sell off. People here are going to have first refusal on those tools once I get the cleanup finished. I did start yesterday, and only got the "top layer" off the workbench. Measuring tools are in the his REM Mfg toolbox at the back of a 42" wide bench, so it could be some time before I get that deep into it.