+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: How To Test A DRO (/thread-1421.html)
How To Test A DRO - EdK - 06-10-2013
Here's an interesting post on another forum about how to test the accuracy of your DRO.
http://www.chaski.org/homemachinist/viewtopic.php?p=165885#p165885
Ed
RE: How To Test A DRO - Highpower - 06-10-2013
Good find Ed. While you are checking the accuracy of the readings, be sure that you check the +/- coordinates as well to make sure they are reading in the proper direction.
