+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: How-To's (http://www.metalworkingfun.com/forum-8.html)
+--- Thread: name that box (/thread-1321.html)
name that box - krv3000 - 04-21-2013
hi all just a little one i had this box don't no where it came form but it was just the right sis for the outside jaws for me burnerd chuck so i thought i wood show you haw i put the lettering on the lettering is dry transfer lettering this cums in all type of font and culer its rather simple to put on i use masking tape as a guide and to mark the center of the box all you do is place the letter where you won't it then rub over the top with a pencil once all the word is dun you must put the peace of tracing paper over the word and rub all over the word t mack shower the lettering is suck dawn once all the text is dun i cote the text with varnish you can use solvent bast lacers on the lettering but you must let the lacer dry thoroughly be for a plying another cote right pics
RE: name that box - EdK - 04-22-2013
RE: name that box - Micktoon - 04-22-2013
Nice job again Bob
, I had wondered how you did that lettering.I am looking forward to seeing your engine build start now you have your cylinder off John
cheers Mick
RE: name that box - krv3000 - 04-23-2013
thanks all yep i have bin descaling the cylinders theirs sum more casting to be dun ie valve chest top and bottom of the cylinders then I'm off o i will be making a new boring bar so their will be a post on that soon