+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Dumpster Dive Results (/thread-2076.html)
RE: Dumpster Dive Results - Dr Stan - 02-08-2015
(01-15-2015, 06:17 PM)EdK Wrote: Hit the mother-load today. Two 3/4" aluminum (aluminium) plates, 18"x15".
Ed
Some have all the luck. BTW
RE: Dumpster Dive Results - Vinny - 02-09-2015
Since it's already got the stepper, looks like a good start for a micro-controller based dividing head.
RE: Dumpster Dive Results - Hopefuldave - 02-09-2015
Yep, but I've already got a 6" rotary table and a tilting 4" with shared dividing plates...
The 4" Needs Attention though, the pivot pin's way off parallel to both the base and the table surface - another skip dive, I'm planning to bore the two castings between centres on the cross-slide boring table up on parallels, then bush to fit the pin back in - possibly adding another cylinder at a sensible centre distance for gauge blocks, sine table-ish? When I get the tuits I'll start a thread :-)
RE: Dumpster Dive Results - mike-sid - 03-15-2015
![[Image: 20150315_102450_zpswevwapbn.jpg]](http://s204.photobucket.com/user/mike-sid/media/metalworking%20fun/20150315_102450_zpswevwapbn.jpg.html)
Found this matched set in my favorite dumpster. New never been mounted no scratches. Corporate America's answer to unwanted parts is to throw them out. Since I don't have the car to fit these, any ideas what these can be used for?
RE: Dumpster Dive Results - Roadracer_Al - 03-15-2015
Google the part numbers and the manufacturer name, and you should be able to find a page that describes what they fit. Next stop, eBay.
This is one downside to being self employed which I had not considered before.... no dumpsters filled using other peoples money.
RE: Dumpster Dive Results - PixMan - 03-15-2015
Monroe Sensa Track p/n 72257 & 72258, left and right for Ford Focus 2006-2011
RE: Dumpster Dive Results - mike-sid - 03-15-2015
(03-15-2015, 03:37 PM)PixMan Wrote: Monroe Sensa Track p/n 72257 & 72258, left and right for Ford Focus 2006-2011
Thanks!
RE: Dumpster Dive Results - PixMan - 03-15-2015
I should have added that they are for the front. One thing I'm wondering about is why aren't they painted black as they should be? Makes me wonder if they were tossed because they skipped the paint or something else wrong with them.
RE: Dumpster Dive Results - mike-sid - 03-15-2015
They are gloss black. Must be my flash. I've seen several new car motor parts in the dumpster . I asked once and was told, not needed or wrong parts ordered so after a while they toss em.
RE: Dumpster Dive Results - Mayhem - 03-15-2015
Any Vauxhall/Opel Z19TD engine parts in there by any chance...