+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Heat treat furnace (/thread-2983.html)
RE: Heat treat furnace - Vinny - 12-23-2015
If it were me, I'd go with two, but there's no engineering schooling on mine either.
RE: Heat treat furnace - dallen - 12-23-2015
take it off both sides so the key stays centered. that's from putting 100 HP drives together with a stepped key in them.
RE: Heat treat furnace - Highpower - 12-23-2015
(12-23-2015, 05:44 PM)dallen Wrote: .... that's from putting 100 HP drives together with a stepped key in them.
Sounds good enough to me! Thanks guys.
RE: Heat treat furnace - f350ca - 12-23-2015
Late reply Willie but any stepped keys I've seen are cut on both sides.