+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: Dual flight controls for simulator (/thread-2017.html)
RE: Dual flight controls for simulator - Hawkeye - 09-13-2014
Man. That's an inspiring thought.
RE: Dual flight controls for simulator - Shawn - 09-26-2014
Pretty happy with the press fit bearing holes I bored today. The axle is a tight sliding fit in both bearings, had to use sandpaper to hit the mark but at least I didn't go past.
![[Image: image.jpg]](http://s28.postimg.org/vlrbs7zpp/image.jpg)
RE: Dual flight controls for simulator - DaveH - 09-27-2014
Nice work Shawn, very nice
DaveH