+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Other Machinery (http://www.metalworkingfun.com/forum-13.html)
+---- Forum: Shapers (http://www.metalworkingfun.com/forum-30.html)
+---- Thread: 16" backgeared Cinci (/thread-1490.html)
RE: 16" backgeared Cinci - dallen - 03-15-2014
here's a little video of it being bored out on the mill.
RE: 16" backgeared Cinci - dallen - 04-10-2014
finally got the part shown in the last video on the shaper it still needs a couple finishing touches.
[attachment=8098]
and the handle that a friend in Tulsa cut the pattern for with his CNC Router
[attachment=8099]
I've made and adjustment to the pattern by removing the rounded part because of the length of the stud that is in the shaper (original part), I plan on scaling the pattern up a little its on the small side for getting a good grip on. But it looks a heck of a lot better then the other one that I cut the pattern for with a pocket knife.
DA
RE: 16" backgeared Cinci - dallen - 04-13-2014
made the thumb screw that I need for the leadscrew support shown in the above photo
small part with a big pucker factor, the gods smiled and I only had to make the one.
[attachment=8116]