+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Lathes (http://www.metalworkingfun.com/forum-11.html)
+---- Forum: Lathe Tooling (http://www.metalworkingfun.com/forum-19.html)
+---- Thread: Making A QCTP Indicator Holder (/thread-864.html)
RE: Making A QCTP Indicator Holder - stevec - 10-24-2012
I'll be following your every move Ed.
RE: Making A QCTP Indicator Holder - EdK - 10-24-2012
(10-24-2012, 07:10 PM)stevec Wrote: I'll be following your every move Ed.
Ah, OK, the pressure is on. I'll try not to disappoint you.
Ed
P.S. We're expecting our first snow tomorrow. 1.4" of the white fluffy stuff. Yuk! I'm getting too old for that stuff.
RE: Making A QCTP Indicator Holder - stevec - 10-24-2012
(10-24-2012, 07:13 PM)EdK Wrote: We're expecting our first snow tomorrow. 1.4" of the white fluffy stuff. Yuk! I'm getting too old for that stuff.Eeeuw!
RE: Making A QCTP Indicator Holder - EdK - 01-05-2013
Finally got back to this project. The large dovetail cutter was too large for the slot so I had to start with the small cutter and mill to its max and then switch over to the large cutter. Small cutter done, now on to the large cutter for the final dimensions.
Ed
[attachment=4223]
RE: Making A QCTP Indicator Holder - sasquatch - 01-05-2013
Very nice work Ed!! (Be sure to mark your'e name and date on things you make!!)
RE: Making A QCTP Indicator Holder - DaveH - 01-06-2013
Looking good Ed
Daveh
RE: Making A QCTP Indicator Holder - EdK - 01-06-2013
The block is done. Just a few small pieces to make and this project is history.
Ed
[attachment=4235]
RE: Making A QCTP Indicator Holder - EdK - 01-16-2013
More progress on this project. Getting close to crossing it off of my long list.
Ed
[attachment=4264]
[attachment=4265]
RE: Making A QCTP Indicator Holder - Highpower - 01-16-2013
Looking good Ed.
I think you have been sandbagging us.....
RE: Making A QCTP Indicator Holder - DaveH - 01-17-2013
Ed,
Nice work
DaveH