+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Lathes (http://www.metalworkingfun.com/forum-11.html)
+--- Thread: Atlas 6 inch saved from scrapper (/thread-661.html)
RE: Atlas 6 inch saved from scrapper - Rickabilly - 10-05-2012
I can't see it either Bill,
Bob, I'll have a look asap, thanks
Regards
Rick
RE: Atlas 6 inch saved from scrapper - Bill Gruby - 10-05-2012
Thanx Bob. That is the same one Rick. Seems like a good unit.
"Billy G"
RE: Atlas 6 inch saved from scrapper - Rickabilly - 10-05-2012
It does seem like fun, but I know me well enough to know that I will need to do it with a bit more of my own style rather than just building off the plan, but I will copy some aspects directly, if not everything.
regards
Rick
RE: Atlas 6 inch saved from scrapper - Bill Gruby - 10-05-2012
Plans are like instructions Rick, but with better pictures. (sometimes) You look them over a few times, get acquainted with the particulars then set them aside and start building. When you mess up you have them to fall back on.
"Billy G"
RE: Atlas 6 inch saved from scrapper - Rickabilly - 10-06-2012
(10-05-2012, 09:56 AM)Bill Gruby Wrote: you have them to fall back on.
What's that Bill? you mean blame don't you?
Regards
Rick