+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Milling Machines (http://www.metalworkingfun.com/forum-12.html)
+--- Thread: [PROJECT] X Power Feed (/thread-2447.html)
RE: X Power Feed - EdK - 02-08-2015
Ken,
I plan on doing some rounding of the edges. Now that I know it all fits together properly I can work on making it prettier.
Ed
RE: X Power Feed - Mayhem - 02-09-2015
Ed - not a criticism but a question: is there any reason you didn't make it out of a single piece? I'm guessing it was what you had in "inventory" but curious if there is another reason.
Either way it is a beautiful bit of work.
RE: X Power Feed - stevec - 02-09-2015
Looking good Ed, glad to read that you plan to round those edges.
RE: X Power Feed - EdK - 02-09-2015
(02-09-2015, 05:10 AM)Mayhem Wrote: Ed - not a criticism but a question: is there any reason you didn't make it out of a single piece? I'm guessing it was what you had in "inventory" but curious if there is another reason.
Either way it is a beautiful bit of work.
As you surmised, inventory dictated what I used.
Well, also I'm following Henry's method and he used a two piece design.
Ed
RE: X Power Feed - EdK - 02-09-2015
(02-09-2015, 07:15 AM)stevec Wrote: Looking good Ed, glad to read that you plan to round those edges.
Ya, those corner are sharp. I think I may taper the sides inward a bit also.
Ed
RE: X Power Feed - stevec - 02-09-2015
Ed, it would be good if you had a power feed to do those corners and tapers.
Steve
RE: X Power Feed - EdK - 02-09-2015
(02-09-2015, 10:33 AM)stevec Wrote: Ed, it would be good if you had a power feed to do those corners and tapers.
Steve
Kind of like needing a welding table to make a welding table.
Ed