+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: drip oilers (/thread-1820.html)
RE: drip oilers - Scruffy - 03-25-2014
My cin 16 shaper only has sprig loaded ball bearing oil holes to oil the ram slides.
Igot a figure out how to post pics of my mature collection then you guys can explain how to use them??
Scruffy Ron kincaid
(09-19-2012, 01:35 PM)stevec Wrote: rleete, Usually a mill table gets loose in the middle where most of the action occurs is there something about the mini mill that's different?
I had the vise on one side and the rotab on the other for a while but found that Murphy's law rules and you've gotta take one or the other of to clear some job.
RE: drip oilers - EdK - 03-25-2014
(03-25-2014, 12:39 PM)Scruffy Wrote: ...
Igot a figure out how to post pics of my mature collection then you guys can explain how to use them??
Scruffy Ron kincaid
Here you go Ron. Ask questions if you run into problems.
How To Post Pictures
Ed