+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Other Machinery (http://www.metalworkingfun.com/forum-13.html)
+---- Forum: Shapers (http://www.metalworkingfun.com/forum-30.html)
+---- Thread: 10.5" Douglas Shaper (/thread-1568.html)
RE: 10.5" Douglas Shaper - TomG - 01-24-2019
This is a pretty old thread John, and unfortunately I haven't heard from any of these guys for quite a while. But there is a thread on Metalwork Forums about a guy who adapted an industrial sewing machine clutch to his Douglas shaper and claims it works very well.
Tom
RE: 10.5" Douglas Shaper - castellated nut - 01-24-2019
(01-24-2019, 10:02 AM)TomG Wrote: This is a pretty old thread John, and unfortunately I haven't heard from any of these guys for quite a while. But there is a thread on Metalwork Forums about a guy who adapted an industrial sewing machine clutch to his Douglas shaper and claims it works very well.
Tom
Tom, thank you for the heads up on the Metalwork Forums, I'll check it out.