+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Other Machinery (http://www.metalworkingfun.com/forum-13.html)
+--- Thread: Shop Press (/thread-1011.html)
RE: Shop Press - starlight_tools - 08-24-2013
(08-24-2013, 11:35 AM)aametalmaster Wrote:(02-01-2013, 09:12 PM)starlight_tools Wrote: So I am thinking again about getting started on a bender. I like the looks of this one from Iroquios Iron Works
Walter
I like that too. Any updates Walter...Bob
Still on the hunt for 1" thick T-1 plate for the base.
Walter
RE: Shop Press - DaveH - 07-29-2014
I upgraded my press to use the air/hydraulic 20T jack.
The jack is held by a 10mm bolt, the 'top foot' was drilled and taped 10mm.
So you could say it is "hanging by a thread" .................
........I don't know where I find them 'hanging by a thread'
[attachment=8932]
I also made a knob for the release valve - just makes life a little eaier.
[attachment=8933]
DaveH
RE: Shop Press - EdK - 07-29-2014
I like the knob you made for the relief valve. I'll need to make one for mine also.
Ed
RE: Shop Press - ETC57 - 07-31-2014
Yes Yes a knob is what I need!!
It's amazing how little time saving things such as a knob never seem to make it into my gray matter!
