+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Boring heads for the mill (/thread-465.html)
RE: Boring heads for the mill - DaveH - 06-23-2012
(06-22-2012, 03:33 PM)Keith_W Wrote: Hi All,Hi Keith,
I am new to this forum and would like to ask if you have had any expriances or knowledge of this Boring Head, Toolmaster VBHU.
I have bought this unit for my Mill but have not used it as yet as am making a few modifications to the Mill Control and fitting a VSD.
Regards,
Keith.
Let me just say 'Welcome to MetalworkingFun' and we hope you are enjoying it here
That looks a very nice boring head, nice addition to your workshop
DaveH
RE: Boring heads for the mill - pineyfolks - 07-25-2012
A simple bar with a tool that can be slid in and out and set with a micrometer will get you by for one time jobs. Make several, setup on a scrap piece and write the bore sizes on them, put them in your toolbox for next time or change them as needed.