+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: CNC (http://www.metalworkingfun.com/forum-28.html)
+--- Thread: Help with Arduino code (/thread-2617.html)
RE: Help with Arduino code - Vinny - 04-06-2015
now disconnect the stepper board and do it again.
RE: Help with Arduino code - EdK - 04-07-2015
Chuck,
Can you run the test again but put your meter right on the Atmel pin for the direction signal and see what it does?
Ed
RE: Help with Arduino code - chucketn - 04-07-2015
The Uno's have surface mount ships and I am afraid of shorting something.
Chuck
RE: Help with Arduino code - chucketn - 04-07-2015
I am worn out by this problem. I have started working on a sketch to input the # of divisions from a 4x4 keypad and will add that to Chuck F's sketch.
I am going to take a break from this for a while to let my head clear. I need to make chips or cast something.
I thank you all for the help and all your efforts in fixing this problem.
Later.
Chuck