+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Material suggestions? (/thread-2610.html)
RE: Material suggestions? - stevec - 04-03-2015
Willie, it's a two way street (or highway) you've certainly cast your bread on the waters and it's good to hear that you've gotten back more than wet soggy bread. (boy! I'm waxing poetic today).
Steve
RE: Material suggestions? - f350ca - 04-03-2015
Great idea Dallen, stepped key material is even available,
RE: Material suggestions? - Highpower - 04-03-2015
No stepped key stock here Greg, but I do have a drawer full of the straight stuff - and a mill.
RE: Material suggestions? - dallen - 04-03-2015
I've seen stepped keys on gear drives that had a 150 and bigger HP motors hooked up to it.