+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: An Engine by 3 Amigo's (/thread-1365.html)
RE: An Engine by 3 Amigo's - krv3000 - 06-30-2014
ok will av a go
RE: An Engine by 3 Amigo's - krv3000 - 07-06-2014
hi all well john did the rest of the castings as per they turned out brill the rest of the gang was their to lend a hand also rob and mick and it was my turn to get the stick with man boobs so my first job was to fill in the background on the valve chest covers to highlight the letter R this was dun by mixing two part epoxy resin with red pant then put to one side to go hard i then machined up the two covers i got beater pics this time then the next job is the valve chest right pics
RE: An Engine by 3 Amigo's - doubleboost - 07-06-2014
Looking good Bob
The bronze is a nice colour match for the cylinder
John
RE: An Engine by 3 Amigo's - Micktoon - 07-06-2014
Hi Bob , I hope you still had time for car booting today mind
, looks like you have been busy , them parts must have still been warm when you started to machine them 
Cheers Mick
RE: An Engine by 3 Amigo's - EdK - 07-06-2014
Ed