Fire Wood Processor - Printable Version

Fire Wood Processor - Printable Version

+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: Fire Wood Processor (/thread-1231.html)

Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

RE: Fire Wood Processor - doubleboost - 03-29-2013

Great job on the engine Drool

Some video of it running would be great
Youtube is the site to use
John

RE: Fire Wood Processor - DaveH - 03-29-2013

Greg,
Super job on the engine

DaveH

RE: Fire Wood Processor - f350ca - 04-09-2013

Attempted a U-tube posting. Here goes.

http://youtu.be/SSx5m6ayrGo

Now for a question.
As you can hear its loud with the stock diffuser (?) on the stack. I tried a small automotive muffler on it yesterday and the result was astounding, silence. It idles smoother too (as expected with some back pressure). Is the back pressure from the muffler going to be hard on the exhaust valves due to the retained heat. I've heard yes and no. Comments please.

RE: Fire Wood Processor - Mayhem - 04-09-2013

Well the video was a success Greg. She certainly seems to be running nice even if she wants to get up and go. I'm guessing a steel crankshaft.

RE: Fire Wood Processor - f350ca - 04-12-2013

Needed another break from the cabinet shop.
The hand crank I've been using is on loan from a friend, he needs it for an engine on a wood splitter. So we started building one last night. Turned the OD and ID from a piece of DOM then step milled the profile, followed by a fairing with a sanding disk. Now to make a handle.

[Image: IMG_0556.jpg]

RE: Fire Wood Processor - TomG - 04-12-2013

Looks Like it'll get the job done Greg. I assume it is meant to engage a pin through the center of the shaft? are you going to heat treat it once you make sure it works properly?

Tom

RE: Fire Wood Processor - f350ca - 04-12-2013

Probably would be a good idea Tom, is DOM tubing heat treatable (again mystery metal, no idea where it came from). I think it has a little more carbon than mild steel. Would have to do it after welding the handle on.

RE: Fire Wood Processor - f350ca - 04-12-2013

Slipped back out to the shop after supper and finished up my crank. If quenching it in water after tigging the handle to the hub constitutes a heat treatment then it got hardened. Looks bent in the photo's,

[Image: IMG_0558.jpg]

RE: Fire Wood Processor - TomG - 04-12-2013

Greg,

Try quenching it in oil and if that doesn't work, try water. If neither makes it hard, you'll need to case harden it. If it does get had by quenching, be sure to temper it so it's not brittle. Just re-heat to a light blue color and let it air cool.

Tom

RE: Fire Wood Processor - doubleboost - 04-13-2013

Hi
Greg
The engine runs very well
Nice to see old motors revived
John