+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Wire clamp tool... (/thread-717.html)
RE: Wire clamp tool... - claudef - 08-16-2012
Ok... so here is the picture, One short piece of steel tubing, the nose piece is a short piece of steel turned with .003 PF in the tube ID then turner the taper. The nut, spring pins and threaded rod is junk I had dragging around. Like I said: fun project, cost nothing and it,s a usefull tool. I also added the first three samples of my test.
ClaudeF
RE: Wire clamp tool... - Highpower - 08-16-2012
(08-16-2012, 07:09 AM)claudef Wrote: Ok... so here is the picture, One short piece of steel tubing, the nose piece is a short piece of steel turned with .003 PF in the tube ID then turner the taper. The nut, spring pins and threaded rod is junk I had dragging around. Like I said: fun project, cost nothing and it,s a usefull tool. I also added the first three samples of my test.
ClaudeF
It sure looks like it works well. Tight and tidy clamps.
RE: Wire clamp tool... - DaveH - 08-16-2012
ClaudeF,
Nicely made tool
Looks like it's works very well too
DaveH