+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: How-To's (http://www.metalworkingfun.com/forum-8.html)
+--- Thread: How to Mill a Pocket on the Vertical Milling Machine (/thread-546.html)
RE: How to Mill a Pocket on the Vertical Milling Machine - TomG - 06-25-2012
(06-25-2012, 11:25 AM)TOM REED Wrote: http://www.homemodelenginemachinist.com/index.php?topic=5495.0 This is the project I want to build and would like to make my own locking pins for the DI chuck 3 of them and would just like to be able to say I built the whole thing pins locks etc without welding, and a small radius in the corner of the pocket would be fine. tom
Tom,
You should be able to mill those. Mill as much of the pocket as you can with a larger end mill then pick the corners out with a smaller diameter, long end mill. I would recommend plunge cutting most of the material out before side milling to keep from breaking the long end mill. This is a good application for carbide because of it's rigidity but you would need to be careful because it's is also very brittle.
I would also suggest making the pins out of O1 so you can easily harden them.
Tom
RE: How to Mill a Pocket on the Vertical Milling Machine - stevec - 06-25-2012
I'd drill the 4 corners with a bit large enough to eat up the radius of the D-I square then drill just shy of the square and finish the sides with an end mill. A little 3/4 hole at each corner isn't gonna affect the torquing of the studs with the key. As a matter of fact it's like a "flank drive"
