+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Milling Machines (http://www.metalworkingfun.com/forum-12.html)
+--- Thread: In the Market (/thread-2702.html)
RE: In the Market - Thumb - 06-17-2015
Any suggestions on the best way to get all that grease off?
RE: In the Market - Hopefuldave - 06-17-2015
Kerosene and lots and lots of rag....
RE: In the Market - arvidj - 06-17-2015
(06-17-2015, 06:32 PM)Thumb Wrote: Any suggestions on the best way to get all that grease off?
I think I used WD-40 to clean my stuff. That and lots of blue paper towels.
RE: In the Market - Thumb - 06-17-2015
Well, I have about 5 gallons of kerosine and lots of paper towels so maybe that will work. I'm moving my table
saw outside so maybe I can take some of that grease and put it on the table to keep it from rusting too. BTW, anyone interested in a 1960 Craftsman table saw that works?
RE: In the Market - arvidj - 06-17-2015
I'm sure kerosene will also get the job done. The aroma in the shop will be different that with WD-40 but the end result will be the same. Good luck!!
RE: In the Market - f350ca - 06-17-2015
WD40 is mostly kerosine, with some nice smelling light oil added.