+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: How to square up an angle plate (/thread-2650.html)
RE: How to square up an angle plate - Sunset Machine - 05-02-2015
My shaper won't stop until the saddle runs off the end of the leadscrew. It needs me.
The angle plate. If there's room, how about using a lathe to flycut it square? Bolt it down in place of the toolpost and rig up a cutter for the 4-jaw.
Here's one for the horizontal mills.
RE: How to square up an angle plate - PixMan - 05-02-2015
Oh, that I could have the room for such things as a horizontal machining center. I would rule the world!