+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Edge Finder Disassembly (/thread-2334.html)
RE: Edge Finder Disassembly - mcostello - 01-19-2015
If easy dis-assembly is Your goal, just "bump" a part too hard when "finding" it in Your mill vise. Finding the spring and reassembling it is another matter.
RE: Edge Finder Disassembly - Baron - 02-15-2015
Hi All,
I thought you might like to see my center finder. Its one that I made recently from a bit of scrap and a cheap (Aldi) laser pointer.
[attachment=10052]
This picture shows the dimensions I used, but its not at all critical. I used an angle of 10 degrees, but if you want to focus more closely to the work then 15 degrees would be better.
[attachment=10053]