+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Other Machinery (http://www.metalworkingfun.com/forum-13.html)
+---- Forum: Band Saws (http://www.metalworkingfun.com/forum-32.html)
+---- Thread: Adjusting/setting up a bandsaw (/thread-1414.html)
RE: Adjusting/setting up a bandsaw - Highpower - 06-10-2013
[attachment=5466]
RE: Adjusting/setting up a bandsaw - Highpower - 06-10-2013
Here is a better view of the wire wheel set-up:
[attachment=5467]
RE: Adjusting/setting up a bandsaw - EdK - 06-10-2013
Here you go Darren.
The article: http://www.machinistblog.com/a-chip-brush-for-the-jet-5x6-bandsaw/
The plans: http://www.machinistblog.com/downloads/A%20Chip%20Brush%20for%20the%20Jet%205X6%20Bandsaw.pdf
That project has been on my list for quite awhile now. I even bought the brushes for it but have just not gotten around to making the modification.
Ed
RE: Adjusting/setting up a bandsaw - DaveH - 06-10-2013
This is how I did it.
DaveH
RE: Adjusting/setting up a bandsaw - Highpower - 06-10-2013
Dave, did you make that bracket? It looks like a factory made part.
RE: Adjusting/setting up a bandsaw - stevec - 06-10-2013
Willie & DaveH, thanks for the circular brush idea. It's now on my list (my long, long list, sigh).
RE: Adjusting/setting up a bandsaw - DaveH - 06-10-2013
(06-10-2013, 04:48 PM)Highpower Wrote: Dave, did you make that bracket? It looks like a factory made part.Sure did,
I assume you meant it as a compliment 
DaveH
RE: Adjusting/setting up a bandsaw - stevec - 06-10-2013
DaveH, I'm sure he meant "non Asian factory made".
RE: Adjusting/setting up a bandsaw - Highpower - 06-10-2013
(06-10-2013, 07:28 PM)stevec Wrote: DaveH, I'm sure he meant "non Asian factory made".
Good point Steve! I guess I should have said it looks TOO good to be a factory part in that case.
It's obviously a heavier bracket than what is on my saw.
