+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Lathes (http://www.metalworkingfun.com/forum-11.html)
+--- Thread: Cross slide lock with a DRO fitted (/thread-1285.html)
RE: Cross slide lock with a DRO fitted - stevec - 04-06-2013
(04-05-2013, 06:28 PM)EdK Wrote: . The dimple would move when you adjusted the gibs so it wouldn't make a lot of sense to design one in.Didn't think of that Ed, so it's not a "good question"
Good question though. I'll check when I take the table apart.
Ed
I guess the brass slug is the way to go.
