+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Lathes (http://www.metalworkingfun.com/forum-11.html)
+--- Thread: Let's See Your Lathe (/thread-15.html)
RE: Let's See Your Lathe - hermetic - 09-28-2019
Here is my lathe, A colchester Student Roundhead Mk1, and a link to the slideshow of it being rebuilt. There was quite a collection of parts loose in the bottom of both gearboxes, but by some miracle it still worked, but it worked a lot better when they were identified, and put back where they should have been! At some point in the future I will change the spindle bearings, as I have a replacement, which is, I suspect, a lot better than the ones it has at the moment. The tell tale was the grey stain running out of the bearing drain hole when I flushed with white spirit, and the fact that the end float has clearly been adjusted with a hammer and punch! Having said all that, it works very well considering the abuse it has obviously suffered.
https://www.youtube.com/user/philhermetic/
RE: Let's See Your Lathe - Dr Stan - 09-28-2019
Very nice.
RE: Let's See Your Lathe - Vinny - 09-29-2019
Looks good!
RE: Let's See Your Lathe - hermetic - 09-30-2019
Thanks for the kind words chaps! It is a pleasure to use , and now that I have put a few little scratches in it, it's mine again!! I have a temporary halogen light above it, but I will take some more pics when I get the original machine light back on it.
Phil, UK
RE: Let's See Your Lathe - dodge lancer 1962 - 09-27-2020
http://village.photos/images/user/d4ab52f1-d81e-42fd-9bc2-37e3046004ea/1bcc9531-8820-4227-bf94-e6ea1b2ab43d.jpg
http://village.photos/images/user/d4ab52f1-d81e-42fd-9bc2-37e3046004ea/ba3cebed-74e7-416e-9a08-27c9d829d6e1.jpg
This is a couple of pictures of my Craftsman Atlas Lathe
Dodge Lancer 1962
RE: Let's See Your Lathe - EdK - 05-14-2021
I couldn't take in any longer being without a lathe so as a temporary solution I ordered this one this evening. I'll get the keeper in the fall. Any lathe is better than no lathe.
Ed
[attachment=16998]
RE: Let's See Your Lathe - Highpower - 05-14-2021
Show off! Mine is only 10 inches. And it's GREEN.
RE: Let's See Your Lathe - Vinny - 05-16-2021
I have an older 7x12, it's yellow.
RE: Let's See Your Lathe - EdK - 05-16-2021
My first lathe was a HF 7x10 so this will be an upgrade from that at least.
Ed
RE: Let's See Your Lathe - EdK - 05-18-2021
I checked the status of my order yesterday morning and on the web page for the lathe I found this message which I hadn't seen when I placed the order.
"Important Information
Item made to order. Average time to ship is 3 weeks with a maximum of 13 weeks."
I decided to wait another day and see what happened. This morning when I checked the status of my order it said it had shipped.
Tracking says it should be here tomorrow.
Ed