+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: P&W 1830 Radial in 1/6 scale. (/thread-573.html)
RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-09-2013
#1 very close to finished. Some relieving and shaping yet. I will get #2 to this point and finish them both at the same time. That is a blank that #1 is resting on. Much waste.
"Billy G"
RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-09-2013
And then there were two almost done. LOL
"Billy G"
RE: P&W 1830 Radial in 1/6 scale. - DaveH - 05-09-2013
Really nicely done Billy
DaveH
RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-09-2013
Bookmatched, they are a done deal.
"Billy G"
RE: P&W 1830 Radial in 1/6 scale. - doubleboost - 05-09-2013
(05-09-2013, 05:00 PM)Bill Gruby Wrote: Bookmatched, they are a done deal.
"Billy G"
Very nice Bill
Small parts scare me
John
RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-09-2013
The "pucker factor" went up considerably while doing these John.
"Billy G"
RE: P&W 1830 Radial in 1/6 scale. - EdK - 05-09-2013
Excellent craftsmanship Billy. Those are really small parts.
Ed
RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-12-2013
Delrin arrived Friday . I have one Distributor cap blank - ready to mill. I will get the other to this point then mill them both.
"Billy G"
RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-12-2013
That's two. Into the mill tomorrow then back into the lathe to finish up.
"Billy G"
RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-13-2013
10 -- .125 X .406 holes done. This one goes back to the lathe. One more to go.
"Billy G"