+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: 3D Printing (http://www.metalworkingfun.com/forum-46.html)
+--- Thread: Share your prints (/thread-4303.html)
RE: Share your prints - Highpower - 07-27-2024
I think I have that set too. Sure would be easier to remove them from that box though than the original plastic pouch that acts like a glue trap.
RE: Share your prints - EdK - 07-27-2024
(07-27-2024, 04:55 PM)rleete Wrote: I have that set. Not sure they deserve a custom box.
Maybe not but they sure are easier to store that way.
Ed
RE: Share your prints - EdK - 07-28-2024
(07-27-2024, 07:29 PM)Highpower Wrote: I think I have that set too. Sure would be easier to remove them from that box though than the original plastic pouch that acts like a glue trap.
You want one?
Ed
RE: Share your prints - Highpower - 07-28-2024
(07-28-2024, 10:37 AM)EdK Wrote:(07-27-2024, 07:29 PM)Highpower Wrote: I think I have that set too. Sure would be easier to remove them from that box though than the original plastic pouch that acts like a glue trap.
You want one?
Ed
Thanks for the offer Ed but no need. It's doubtful I'll ever use them again much less repeatedly. But if I do I'll just toss them in a zip-lock bag next time.
RE: Share your prints - EdK - 08-17-2024
I've been wanting to do this for some time now so I finally got'r done. It's a cover for my surface plate. Those marks on the top are from the glue stick that I use to hold down the item being printed.
Ed
[attachment=18723] [attachment=18724]
RE: Share your prints - JScott - 08-17-2024
Is that a cover for the surface plate?
RE: Share your prints - EdK - 08-17-2024
(08-17-2024, 03:39 PM)JScott Wrote: Is that a cover for the surface plate?
Yup.
Ed
RE: Share your prints - Highpower - 08-17-2024
Wait.... Is that an unused horizontal storage surface I see???
RE: Share your prints - EdK - 08-17-2024
(08-17-2024, 10:02 PM)Highpower Wrote: Wait.... Is that an unused horizontal storage surface I see???
Yup, but it usually has stuff piled on it so that's why I wanted to make the cover for it.
Ed
RE: Share your prints - rleete - 08-17-2024
I'm disappointed that you didn't put "surface plate cover" on the side. How will you know what's under there?