+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Any Logan Shaper advise? (/thread-924.html)
Pages:
1
2
RE: Any Logan Shaper advise? - Sunset Machine - 10-20-2012
(10-19-2012, 10:34 AM)TOM REED Wrote: Sunset down the road a ways if you are thinking of getting rid of your shaper I would be interested. tom
Maybe next summer? I've had it a year and it's the first machine I've owned that hasn't endeared itself to me. There's just no love there...
I have a planer that overlaps, maybe exceeds what a shaper can do, so things are kind of redundant. The shaper is a 100 year old Lutter & Gies, a 16" model that I've posted pics of here before. Good condition. Looking for $500 and it's sitting on a really rough concrete floor. Rolled it in on 3/4" pipes after a forklift set it in the doorway. The forklift rental was $200 and if they bring the right one this time, we can probably avoid the pipe rollers.
We'll see. Maybe once it figures out that I'm about to kick it to the curb it'll act nicer to me.
Thanks for asking!
RE: Any Logan Shaper advise? - f350ca - 10-20-2012
There's no proof you bought it, actually could be just a tall tale like a Sasquatch sighting unless we see pictures
RE: Any Logan Shaper advise? - stevec - 10-20-2012
Pics YA! but with words too!
RE: Any Logan Shaper advise? - sasquatch - 10-20-2012
i gotta get it home first guys,, i can't pick it up untill monday.
RE: Any Logan Shaper advise? - f350ca - 12-07-2013
Hey we still have no proof of ownership without a photo.
BUT I'd let you off the hook if you'd measure the motor pulley for me, mine had a 3 inch but the 1 1/2 inch I put on it made a big difference in the noise, almost quiet now.
RE: Any Logan Shaper advise? - sasquatch - 12-07-2013
Greg, Surprised to see this old post. Lol,,, anyway, I did post pics here of my amature restoration in ?? "Other machines" back quite awhile ago.
Hang on,, i'll run and measure that drive pulley,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,, Ok,,, my motor pulley measures 2 inch. That's what was on mine when i found it anyway, and it seems to work fine.
Belt up to the vari-speed, then the drive on the shaper measures 8 inch.
(Found out after mine is a "Porter Cable" pre 1941, before Logan bought the machine division from them. Basicly the same machine from what i can see.
RE: Any Logan Shaper advise? - f350ca - 12-07-2013
THANKS, will give a 2 inch one a try, didn't have one in stock, the 1 1/2 is slipping when I put a good load on it, the 2 inch will probably make a big difference.