+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: 3D Printing (http://www.metalworkingfun.com/forum-46.html)
+--- Thread: [HELP] Printing Problem (/thread-4214.html)
Pages:
1
2
RE: Printing Problem - Vinny - 07-29-2020
Just don't leave it in a hot car!
RE: Printing Problem - arvidj - 07-29-2020
(07-29-2020, 09:38 PM)Vinny Wrote: Just don't leave it in a hot car!
Would PETG or ABS survive a hot car?
RE: Printing Problem - EdK - 07-30-2020
(07-29-2020, 09:38 PM)Vinny Wrote: Just don't leave it in a hot car!
It's going in a dresser drawer so won't see too much heat, at least for Arizona.
Ed
RE: Printing Problem - Vinny - 07-30-2020
(07-29-2020, 09:57 PM)arvidj Wrote:(07-29-2020, 09:38 PM)Vinny Wrote: Just don't leave it in a hot car!
Would PETG or ABS survive a hot car?
I've never done anything with PETG, but I know ABS is ok. I've seen pics of PLA printed items that were left on the seat of a car for just an hour or so that no longer looked the same! I switched my filament printing to ABS after that. I have a sampler pack of filament from MicroMark that they no longer sell. It has PETG, and some others including wood and iron, and they say the iron will even rust, also the wood can be sanded and stained.
RE: Printing Problem - EdK - 07-30-2020
Got'r done!
Ed
[attachment=16715] [attachment=16716]
[attachment=16717]
RE: Printing Problem - Vinny - 07-31-2020
It looked so much bigger before there was something to reference it! Looks good!!
RE: Printing Problem - EdK - 08-12-2020
Just to close this out, the printer did a good job of printing what I needed.
Ed
[attachment=16725]
RE: Printing Problem - arvidj - 08-14-2020
Ed, what are you using as your CAD tool? And then what is the work flow?
Thanks,
Arvid
RE: Printing Problem - EdK - 08-14-2020
Arvid,
I always draw my projects using Solid Edge 2D to get the dimensions down. Then I use FreeCAD to create the model and export it as an STL file.
Ed