+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Milling Machines (http://www.metalworkingfun.com/forum-12.html)
+--- Thread: A fix for bad fitting splines in Chinese mills (/thread-393.html)
Pages:
1
2
RE: A fix for bad fitting splines in Chinese mills - Dave J - 12-24-2012
My original fix was just for noise and like you say it was fine under constant load. The noise would come when the tool unloaded then as it loaded up the spline would knock.
After all this time the sleeve is still doing it's job well.
Dave