+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Other Machinery (http://www.metalworkingfun.com/forum-13.html)
+--- Thread: Wondering about a t&c grinder (/thread-3504.html)
Pages:
1
2
RE: Wondering about a t&c grinder - Pete O - 03-07-2017
I didn't get the guy's details unfortunately, I had to leave in a hurry to get to work after chatting for a bit and just left him with my email address. I'm not all that devastated, there are other things higher on the priority list.
RE: Wondering about a t&c grinder - Dr Stan - 03-08-2017
(02-28-2017, 12:37 PM)Vinny Wrote:(02-28-2017, 12:39 AM)Dr Stan Wrote: I ended up going with a surface grinder and an end mill sharpening attachment.
Thanks DOC! Last thing I needed to do was spend more money. Just found one on ebay, new, from Travers for $67. Supposed to be here later in the week.
So when will you buy a tool post grinder such as a 1hp Dumore?
RE: Wondering about a t&c grinder - Vinny - 03-08-2017
No desire for a tool post grinder. Too much dust on the ways and other non desired places.