+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: [HELP] Cutting a flute on a tap (/thread-2841.html)
Pages:
1
2
RE: Cutting a flute on a tap - Mayhem - 09-20-2015
Nice job.
RE: Cutting a flute on a tap - TomG - 09-20-2015
Nice job Anthony!
Making your own tap definitely gives one a feeling of satisfaction.
Tom
RE: Cutting a flute on a tap - Hopefuldave - 09-25-2015
Nicely done!
An alternative to soap that I've had good results with: Tippex / Snopaque / typist's correction fluid (does anyone really use tripewriters any more?), also useful to stop solder or braze from spreading where you don't want it - the old solvent-based stuff was better than the water-based, but it still works now it's been elfin safetied...