MetalworkingFun Forum
cutter breakage - Printable Version

+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: cutter breakage (/thread-2518.html)

Pages: 1 2


RE: cutter breakage - Mayhem - 02-16-2015

(02-15-2015, 07:42 PM)PixMan Wrote: Chip load per tooth.

Too high = excess load and the cutter "hogs in" and breaks
Too low = rub the sharp edge dull

Sort of like "Goldilocks and the three machinists"...