+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: How-To's (http://www.metalworkingfun.com/forum-8.html)
+--- Thread: mill head to table align' (/thread-2508.html)
Pages:
1
2
RE: mill head to table align' - CNCAZ - 10-29-2015
I always put 1-2-3 blocks on the table and tram the head to them. That way the indicator tip doesn't have go over the T-slots. I use a co-axial indicator holder to be able to sweep a wide area.
RE: mill head to table align' - dallen - 10-29-2015
go to the parts store and get yourself a cheap brake rotor that is big enough to cover the table and use that to run the indicator on