+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: just a lil tap (/thread-2284.html)
RE: just a lil tap - krv3000 - 09-14-2014
i think you will need both pears of glasses on john to see 2mm
RE: just a lil tap - RobWilson - 09-15-2014
(09-14-2014, 05:15 PM)krv3000 Wrote: i think you will need both pears of glasses on john to see 2mm
And Hubble
Nice going Bob
Rob
RE: just a lil tap - EdK - 09-15-2014
As usual,
Ed
RE: just a lil tap - krv3000 - 09-19-2014
hi got a bit more dun set them up in the 4 jaw chuck and turned dawn one end to 8.5mm then a cup-er and sum chocolate stopped work
RE: just a lil tap - RobWilson - 09-21-2014
Looking good Bob .
Is that were my Toblerone went to lol
Rob
RE: just a lil tap - krv3000 - 09-22-2014
yep
RE: just a lil tap - RobWilson - 09-22-2014
Fat GIT !
Rob
RE: just a lil tap - krv3000 - 10-01-2014
hi all well i have finisht off the taps still sum work to do on them two need bowls on the top the other 4 need elbows on the frunt and all need drilling and taping m4 to fit on to the cilinders pics
RE: just a lil tap - doubleboost - 10-01-2014
Very nice Mate
RE: just a lil tap - Micktoon - 10-01-2014
I was examining these taps in person the other day and they look better than in these photos ........... as you would expect from wor Bob , a top class job
Cheers Mick