+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Lathes (http://www.metalworkingfun.com/forum-11.html)
+---- Forum: Lathe Tooling (http://www.metalworkingfun.com/forum-19.html)
+---- Thread: Carriage Stop (/thread-1897.html)
Pages:
1
2
RE: Carriage Stop - Hawkeye - 12-16-2013
I looked around for a piece of rod to use for the stop and spotted a broken tap. Chucked it in a drill to spin against the grinder to clean up the broken end and take the tops off the teeth. I ground the pointy end to give it a small flat - less sensitive to swarf than the 1/4" diameter rod on my other lathe.