+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Milling Machines (http://www.metalworkingfun.com/forum-12.html)
+---- Forum: Mill Tooling (http://www.metalworkingfun.com/forum-20.html)
+---- Thread: Multiple Drawbar / Arbour Threads (/thread-1764.html)
Pages:
1
2
RE: Multiple Drawbar / Arbour Threads - Mayhem - 10-06-2013
Ed, the high would increase as the adaptor would add to the OAL of the section of the NTMB 30 inside the spindle. Thus more vertical space between the tool and the work is requires to remove the tool (i.e. The NTMB 30 from the spindle, not when changing endmills).
RE: Multiple Drawbar / Arbour Threads - EdK - 10-06-2013
(10-06-2013, 05:47 PM)Mayhem Wrote: Ed, the high would increase as the adaptor would add to the OAL of the section of the NTMB 30 inside the spindle. Thus more vertical space between the tool and the work is requires to remove the tool (i.e. The NTMB 30 from the spindle, not when changing endmills).
OK, I see what you're saying now. Good point.
Ed
RE: Multiple Drawbar / Arbour Threads - dallen - 10-07-2013
I'm going to act stupid, but if you have the height to remove and install the drawbar why not just use multiple drawbars?? it really can't take that much longer to change both the holder and bar then it is to change just the holder unless I'm missing something.
DA
RE: Multiple Drawbar / Arbour Threads - Mayhem - 10-07-2013
Not missing anything Dave and the 3 bar option is the one I am leaning towards but I thought I would throw the other options I had considered out here and see what happens.
You guys have a lot more experience and it would be silly of me not to try and tap into that.
RE: Multiple Drawbar / Arbour Threads - Mayhem - 05-05-2016
To close this thread: http://www.metalworkingfun.com/thread-578-post-48364.html#pid48364