+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Welding & Casting (http://www.metalworkingfun.com/forum-9.html)
+--- Thread: crank handle for Cincinnati 16" shaper (/thread-1690.html)
Pages:
1
2
RE: crank handle for Cincinnati 16" shaper - awemawson - 11-22-2013
Now isn't that nice
I was only looking at a similar crank on my shaper earlier in the week thinking I needed to clean up a light covering of surface rust - now if I had your bronze one a bit of damp wouldn't matter !
Andrew
RE: crank handle for Cincinnati 16" shaper - dallen - 11-22-2013
(11-22-2013, 11:56 AM)awemawson Wrote: Now isn't that nice
I was only looking at a similar crank on my shaper earlier in the week thinking I needed to clean up a light covering of surface rust - now if I had your bronze one a bit of damp wouldn't matter !
Andrew
thats one way to look at it, I just wanted one out of bronze because I had the metal to do it with and it would be something that most others wouldn't have and its going to look pretty good when all shined up.
DA
RE: crank handle for Cincinnati 16" shaper - doubleboost - 11-22-2013
Nice
Proportions are spot on
John
RE: crank handle for Cincinnati 16" shaper - dallen - 11-22-2013
(11-22-2013, 03:50 PM)doubleboost Wrote: Nice
Proportions are spot on
John
Thanks John. the square end is actually a little on the large side and could be smaller in diameter to lighten it up a bit.
RE: crank handle for Cincinnati 16" shaper - DaveH - 11-24-2013
Wow! very nice
You could put that on the mantelpiece as an ornament
DaveH